Products - Chamber Reamers for Shotgun Chambers
Pre-Rougher Reamer for Shotgun Chambers
- chamber reamer - pre rougher reamer for shotgun chambers
This tool is used for pre-roughing of the cartridge chamber.
The tool has a cylindrical shank and a square for use with a T-handle.
The guide is interchangeable and in the standard version made of brass.
The pre-rougher has large flutes for fast working.
The high-speed profile gives short chips and less cutting force.
Optional fluted pilots are available.
Optional carbide coatings are available.
Rougher Reamer for Shotgun Chambers
- chamber reamer - rougher reamer for shotgun chambers
This tool is used to pre-cut the chamber for a shotgun cartridge, but without rim.
The tool has a cylindrical shank and a square for use with a T-handle.
The guide is interchangeable and in the standard version made of brass.
The diameter dimensions of the standard rouger are 0,15mm under CIP minimum.
So the chamber is cut close to minimum dimension.
Optional fluted pilots are available.
Optional carbide coatings are available.
Finisher Reamer for Shotgun Chambers
- chamber reamer - finisher reamer for shotgun chambers
This tool is used to cut the chamber for a shotgun cartridge, but without rim.
The tool has a cylindrical shank and a square for use with a T-handle.
The guide is interchangeable and in the standard version made of brass.
The diameter dimensions of the standard finisher are 0,07mm over CIP minimum.
So regrinding is possible.
Before using a finisher, it is recommended to use a rougher.
When beginning to cut a pre-roughed chamber, you must work very carefully,
to avoid the reamer to “hook in”.
If minimum chambers are needed, use a minimum reamer.
Optional fluted pilots are available.
Optional carbide coatings are available.
Complete Reamer for Shotgun Chambers
- chamber reamer - complete reamer for shotgun chambers
This tool is used to cut the chamber for a shotgun cartridge with rim and forcingcone.
The tool has a cylindrical shank and a square for use with a T-handle.
The guide is interchangeable and in the standard version made of brass.
The diameter dimensions of the standard finisher are 0,07mm over CIP minimum.
So regrinding s possible.
Before using a finisher, it is recommended to use a rougher.
When beginning to cut a pre-roughed chamber, you must work very carefully,
to avoid the reamer to “hook in”.
If minimum chambers are needed, use a minimum reamer.
Optional fluted pilots are available.
Optional carbide coatings are available.